Restarting The Subsystem - Asus DS300j G2 Series User Manual

S aSuS DS300 G2 – S
tartInG uP the f
Important
If you have a JBOD Expansion, always power on the JBOD subsystems first. Then
power on the RAID subsystem.
To start the RAID subsystem:
1. Manually turn on the system by pressing the power button on the front left side
2. Wait about two minutes
3. Establish a serial connection to the ASUS DS300f G2.
See Making a Serial Connection.
When the Login: prompt appears, the start up is finished.
4. Type menu and press Enter to open the CLU.
170
c
erIal onnectIon
r s
estartInG the ubsysteM
There are two methods for restarting the subsystem. Choose one of the following procedures:
• "Restarting ASUS DS300f G2 – Telnet Connection" on page 170
• "Restarting ASUS DS300f G2 – SSH Connection" on page 171
• "Restarting ASUS DS300f G2 – Serial Connection" on page 171
Note
If you have a JBOD Expansion, you are not required to restart the JBOD subsystems when you restart
the RAID subsystem.
•
r aSuS DS300 G2 – t
eStartInG f elnet
To restart the RAID subsystem:
1. From the Main Menu, highlight Additional Info and Management and press Enter .
2. Highlight Shutdown or Restart and press Enter .
3. Highlight Option and press the spacebar to display Restart .
4. Highlight Submit and press Enter .
A warning message appears.
5. Press Y to continue.
The screen goes blank.
6. Wait about two minutes.
7. Re-establish your Telnet connection to the ASUS DS300f G2 CLU.
See Making a Telnet Connection.
If you cannot re-establish a connection, wait 30 seconds and try again.
DS300f G2 Series User Manual
c
onnectIon