Epson Stylus Pro 7700 Service Manual page 431

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908
MOUNTER ONLY TEST'S PROCEDURE
Preparation
1. Start the inspection program.
2. Connect the mounter to the computer with a USB cable.
3. Turn on the mounter.
NOTE: When the computer recognizes the mounter a wizard screen is
displayed, click on the [Cancel] button.
4. Select MOUNTER ONLY TEST
Figure 5-89. [MOUNTER ONLY TEST] Menu Screen
ADJUSTMENT
from the inspection program.
Sensors check
1. Select Sensors check
2. When the following screen appears, remove the mounter from the printer.
(It is OK to detach the right side of the mounter from the printer slightly.)
Figure 5-90. [Sensor check] Screen
3. Click on the [OK] button.
4. Confirm the blue screen appears, click on the [OK] button.
Figure 5-91. Confirmation Screen
Tests
from the inspection program.
Revision I
431
Confidential