Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908
→
5.
Select
SELF TESTING
Mecha Adjustment
6.
Press [OK] while
[Enter] Un Cap
The carriage unit will be unlocked.
7.
Open the Front Cover (Middle).
8.
Loosen the head tilt lever securing screw shown in
9.
Move the head tilt lever to up and down and adjust the slant of the Printhead.
CR scan direction
Top side is slanted to the left
Lever up
10. Tighten the screws that loosened in
11. Close the Front Cover (Middle).
12. Print the adjustment pattern again and check the adjustment result.
13. Repeat
Step 4
to
Step 12
till the adjustment is finished.
14. After finishing the adjustment, press [OK] while
the Printhead. Then, turn the printer OFF and finish the adjustment.
ADJUSTMENT
→
Temporary
PG.
is displayed.
Figure
5-36.
CR scan direction
Top side is slanted to the right
Lever down
Step
8.
[Enter] Cap
is displayed to cap
Head Related Adjustments
Head tilt lever securing screw
Head tilt lever
Figure 5-36. Head tilt lever
Revision I
382
Confidential