Epson Stylus Pro 7700 Service Manual page 291

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908
8. Disconnect the connectors (CN408, CN409) and FFC (CN400) from the Ink
Holder Board Assy L.
Use a stubby driver or a ratchet driver for the following procedure.
C H E C K
P O I N T If you do not have such a driver, remove the Ink Cartridge Holder
L before disassembly.
9. Remove the five screws that secure the plate.
A) Silver, Phillips, Bind P-tite M3x10: five pieces
10. Remove the plate.
11. Remove the ten screws that secure the Ink Holder Board Assy L.
B) Silver, Phillips, Bind S-tite M3x6: two pieces
C) Silver, Phillips, Bind P-tite M3x10: eight pieces
12. Remove the Ink Holder Board Assy L.
Be careful not to damage the CSIC terminal when removing/
installing the Ink Holder Board Assy L.
- Back of Ink Holder Board -
DISASSEMBLY & ASSEMBLY
(see p284)
Terminal
Disassembly and Assembly Procedure
CN400
Ink Holder Board Assy L
Figure 4-143. Removing the Ink Holder Board Assy L
Be sure to refer to Chapter 5 "Adjustment"
A D J U S T M E N T
R E Q U I R E D
specified adjustments after replacing the Ink Holder Board Assy L.
<Adjustment Item>
1. Ink Holder Adjustment
Revision I
Plate
A
CN409
CN408
B
C
(see p351) and perform
Confidential
291