Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908
15. Remove the two screws, and detach the Ink Tubes.
A) Silver, Phillips, Bind machine screw M2x16 (bit: No.1): two pieces
Use a torque driver with the torque given below when
tightening the screws securing the Ink Tube.
3±0.5kgf⋅cm
Make sure to install the SEAL RUBBER, JOINT, ASP. The
SEAL RUBBER, JOINT, ASP (1518317) is not included in the
Ink Cartridge Holder and the Ink Tube; therefore, re-use the
originally installed one. Make sure to confirm there is no
damage or no foreign material attached on the sealing rubber
or the joint section visually then. Installing a damaged part
such as mentioned above may cause ink leakage.
SEAL RUBBER, JOINT, ASP
16. Remove the six screws that secure the Ink Cartridge Holder Mounting Plate, and
remove the Ink Cartridge Holder Mounting Plate.
B) Silver, Phillips, Round Washer Head S-tite M4x8: four pieces
C) Silver, Phillips, Round Washer Head S-tite M3x6: two pieces
DISASSEMBLY & ASSEMBLY
- Right side -
Disassembly and Assembly Procedure
A
Figure 4-132. Detaching the Ink Tube
Revision I
282
Confidential