Epson Stylus Pro 7700 Service Manual page 437

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908
Paper holder check
1. Select Paper holder check.
2. If the following screen appears, click on the [OK] button.
Figure 5-105. [Paper holder check] Screen
3. While the following screen is displayed, check the status of
Plate. Confirm the whole Paper Pressing Plate is touching the backing without any gap.
If any abnormality is found, check the following.
Symptom
Check the installation status of Paper Pressing Plate.
Check the status of Paper Pressing Motor, and if any abnormality
found, correct it.
Paper Pressing Plate does Check the status of Paper Pressing Encoder, and if any abnormality
not operate. found, correct it.
Check the Paper Pressing Plate Sensor, and if any abnormality
found, correct it.
Install the backing if not installed.
ADJUSTMENT
Paper Pressing
Remedy
(p. 349)
Tests
Figure 5-106. Confirmation Screen
No gap in between
Figure 5-107. Check Point
Revision I
437
Confidential