Epson Stylus Pro 7700 Service Manual page 223

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908
4.4.2.17 Front Cover Sensor L
1. Remove the IC Cover L and the IC Shaft Cover L.
2. Remove the Maintenance Tank L.
NOTE: There is no Maintenance Tank (L) mounted for the Epson Stylus Pro
7700/7710/7700M/7710M/7900/7910/WT7900/WT7910/7890/7908.
3. Remove the Left Cover. (p209)
4. Remove the Rear Cover. (p220)
5. Remove the Ink Tube Guide.
Step 8
( in "4.4.5.6 Cutter Unit"
NOTE: Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910 only
6. Disconnect the two connectors (CN001, CN301) on the Power Supply Board
Assy.
7. Remove the two screws that secure the PS Board Mounting Plate, and remove the
PS Board Mounting Plate.
A) Silver, Phillips, Bind machine screw M3x6: two pieces
8. Disconnect the connector (CN22) on the Main Board.
9. Release the cables from the seven clamps and the saddle.
DISASSEMBLY & ASSEMBLY
(p206)
(p208)
(P. 257))
See Figure 4-40.
Disassembly and Assembly Procedure
- As seen from the rear -
CN301
A
Figure 4-39. Removing the PS Board Mounting Plate
- As seen from the rear -
CN22
Main Board Assy
Figure 4-40. Releasing the harnesses
Revision I
PS Board Mounting Plate
Power Supply Board Assy
CN001
A
Saddle
Clamp
223
Confidential