Epson Stylus Pro 7700 Service Manual page 346

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908
4.4.8.17 Paper Pressing Motor
1. Remove the Color Measurement Device.
2. Remove the Mounter. (p327)
3. Remove the Paper Pressing Encoder.
In the next steps, take care not to damage the scale of the Paper
C A U T I O N
Pressing Encoder.
4. Remove the screw that secures the Carriage Motor mounting plate, and remove the
Carriage Motor Mounting Plate.
A) Silver, Phillips, Bind machine screw M4x8: one piece
5. Disconnect the relay connector of the Paper Pressing Motor.
6. Release the harness from the clamp.
7. Remove the two screws that secure the Paper Pressing Motor, and remove the
Paper Pressing Motor.
B) Silver, Phillips, Bind machine screw M3x4: two pieces
Be sure to refer to Chapter 5 "Adjustment"
A D J U S T M E N T
R E Q U I R E D
specified adjustments after replacing the Paper Pressing Motor.
<Adjustment Item>
1. Counter Clear (Paper Pressing Motor)
DISASSEMBLY & ASSEMBLY
(p325)
(p340)
(see p351) and perform
Disassembly and Assembly Procedure
Carriage Motor mounting plate
A
Figure 4-224. Removing the Carriage Motor mounting plate
Relay connector
Clamp
Paper Pressing Motor
Figure 4-225. Removing the Paper Pressing motor
Revision I
B
346
Confidential