Epson Stylus Pro 7700 Service Manual page 339

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908
4.4.8.13 LED
1. Remove the Color Measurement Device.
2. Remove the Mounter. (p327)
3. Remove the Front Cover. (p331)
4. Remove the Right Cover. (p328)
5. Disconnect the connector (CN23) on the Main Board.
6. Remove the two screws that secure the USB Housing, and remove the USB
Housing.
A) Black, Phillips, Bind machine screw M3x6: two pieces
7. Release the harness of the LED from the cable guide, and remove the LED.
Make sure to route the harness as shown in the figure.
DISASSEMBLY & ASSEMBLY
(p325)
Disassembly and Assembly Procedure
Main Board
CN23
USB Housing
Figure 4-212. Removing the USB Housing
Routing
Cable guide
Figure 4-213. Removing the LED
Revision I
A
LED
339
Confidential