Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908
4.4.3.3 Sub Board Assy
1.
Remove the Control Panel.
(p203)
2.
Remove the IC Cover R and the IC Shaft Cover R.
3.
Remove the Maintenance Tank R.
4.
Remove the Right Cover.
(p209)
5.
Remove the IC Cover L and the IC Shaft Cover L.
6.
Remove the Maintenance Tank L.
NOTE: There is no Maintenance Tank (L) mounted for the Epson Stylus Pro
7700/7710/7700M/7710M/7900/7910/WT7900/WT7910/7890/7908.
7.
Remove the Left Cover.
(p209)
8.
Remove the Top Cover.
(p214)
9.
Unlock the Carriage Unit.
(p201)
10. Disengage the four hooks on the bottom, and remove the CR Belt Cover.
11. Disconnect all the cables and FFC on the Sub Board Assy.
DISASSEMBLY & ASSEMBLY
(p206)
(p208)
(p206)
(p208)
Disassembly and Assembly Procedure
CR Belt Cover
Figure 4-51. Removing the CR Belt Cover
CN118 CN114 CN113
CN111
CN112
CN116
CN104
CN106
CN105
Figure 4-52. Connector locations
Revision I
Hook
CN101
CN100
231
Confidential