Table of Contents
Advertisement
G
CM8A
Assign the Called Party Numbering Plan Iden-
tifier.
H
• When providing Tandem Connection (COT/ODT/LDT/DTI to ISDN, ISDN to COT/ODT/LDT/
DTI), do the following programming.
H
CM08
Specify whether the busy tone is sent to a call-
ing party of ISDN when a called party is busy
in the tandem connection (ISDN to COT).
CM36
Specify the combination of trunk routes allow-
ing the tandem connection.
CM41
Specify the timing start when making an ISDN
call from a station (PB/DP telephone D
Attendant Console for the Tandem Connec-
tion.
NOTE 1:
By using CM41 Y=0>57, an ISDN call is available even if "#" is not dialed.
NOTE 2:
CM41 Y=0>57 is effective for dialing a called number. When dialing a called party sub-
address, this command is not effective.
I
DESCRIPTION
DESCRIPTION
term
CHAPTER 3 SYSTEM DATA PROGRAMMING
•
Y=5000-5255
LCR Pattern No. 000-255
(1)
158: Called Party Numbering Plan Identifi-
er
(2)
00
01
03
04
08
09
NONE : Unknown
(1)
407
(2)
0 : Available (BT)
1 : Not available (RBT)
•
Y=0
(1)
XX ZZ
XX: 00-63: Incoming Trunk Route
ZZ : 00-63: Outgoing Trunk Route
0 : Allowed
(2)
1 : Restricted
•
Y=0
) or
(1)
57
(2)
03-14: 3-14 seconds
If no data is set, the default setting is 10 seconds.
– 111 –
ISDN-BRI PROGRAMMING
DATA
: Unknown
: ISDN/Telephone Numbering
Plan
: Data Numbering Plan
: Telex Numbering Plan
: National Numbering Plan
: Private Numbering Plan
DATA
NWA-008852-001 Rev.5.0
98ch3001.fm
Advertisement
Table of Contents
