Brt Cable Connection Via Mdf - Philips SOPHO 2000 IPS User Manual

BRT Cable Connection via MDF

Connect the cable to a NT1 equipment via the MDF as shown below.
• Location of AP Slots and LTC Connectors for BRT
• Example of MDF Cross Connection for BRT
• For BRT/2BRT/4BRT (AP00-AP07 slot)
PBX
BWB
BRT
LTC0/LTC1/LTC2/LTC3
CONNECTOR
• For 4BRT (AP08-AP11 slot)
Connect No. 0 and No. 1 circuit via the LTC connector, and No. 2 and No. 3 via the CN2
connector.
PBX
BWB
BRT
LTC0/LTC1/LTC2/LTC3
CONNECTOR
(FOR No. 0 AND No. 1 CIRCUIT)
NOTE: Make the installation cable by using the connector attached with the PN-4BRTA-A card.
BRT Cable Connection via MDF
TWISTED-PAIR
CABLE
MAXIMUM 1000 m (3280 ft.)
CN2 CONNECTOR
(FOR No. 2 AND No. 3 CIRCUIT)
NOTE
TWISTED-PAIR
CABLE
MAXIMUM 1000 m (3280 ft.)
INSTALLATION PROCEDURE FOR ISDN-BRI
Page 66
Page 67
MDF
MDF
– 65 –
CHAPTER 2 INSTALLATION
NT1
NT1
NWA-008852-001 Rev.5.0
98ch2001.fm