Point-To-Point Connection - Philips SOPHO 2000 IPS User Manual

Point-to-Point Connection

ISDN Terminal/TA
START
CMAC Assign the point-to-point connection as the
Layer 2 data link.
NOTE:
Assign the Non-Automatic TEI Assignment.
Assign the Extended Passive Bus.
A
Maximum 1965 ft. (600 m)
DESCRIPTION
When Point-to-Point Connection is selected, the PBX will address the BRI Terminal with
channel select (B1/B2) message. Some BRI Terminals cannot answer the call with this type
of signaling. Some of the BRI Terminals require a Calling Party Number sent from the
PBX. In this case, use Point-to-Multipoint for CMAC Y=01 and CM1B to assign extension
number for the BRI Terminal.
CHAPTER 3 SYSTEM DATA PROGRAMMING
MDF
• Y=01
(1) XX Z
XX: 00-15: ICH No.
INITIAL
Z : 0-7: ISDN Line No. of ICH card
(2) 0: Point-to-Point Connection
• Y=02
(1) XX Z
INITIAL
XX: 00-15: ICH No.
Z : 0-7: ISDN Line No. of ICH card
(2) 0: Non-Automatic TEI Assignment
• Y=03
(1) XX Z
INITIAL
XX: 00-15: ICH No.
Z : 0-7: ISDN Line No. of ICH card
(2) 0: Extended Passive Bus
– 170 –
ISDN TERMINAL DATA PROGRAMMING
PBX
ILC
DATA
: 0-1: ISDN Line No. of ILC
(PN-2ILCC) card
: 0-1: ISDN Line No. of ILC
(PN-2ILCC) card
: 0-1: ISDN Line No. of ILC
(PN-2ILCC) card
NWA-008852-001 Rev.5.0
98ch3002.fm
SEPTEMBER/15/2006