Lamp Indications
LAMP
COLOR
NAME
RUN
Green
LC
Green
LPB
Green
PCM
Red
MFRM
Red
FRM
Red
MRMT
Red
RMT
Red
CRC
Red
AIS
Red
BL
Red
NOTE:
The following table shows the lamps of PN-DTB card used for T1/E1 interface.
LAMP
RUN
LC
LPB
PCM
MFRM
FRM
Flashes at 120 IPM while this card is operating normally.
Remains lit when communications are normally ongoing with the D
channel data links connected.
Remains lit when loopback test is in progress.
Remains lit when detecting PCM signal loss.
Remains lit when detecting Multi-Frame Alignment signal loss on time
slot 16 (Only for E1).
Remains lit when detecting Frame Alignment signal loss.
Remains lit when receiving the alarm from a distant office because
Multi-Frame Alignment signal loss has been detected at the distant
office (Only for E1).
Remains lit when receiving Frame Alignment signal loss alarm from a
distant office.
Remains lit when detecting Cyclic Redundancy Checking (CRC) errors
(Only for T1).
Remains lit when a pattern of consecutive "1" is received.
The distant office transmits this signal for a loopback test.
B channel status
ON
OFF
Flash (60 IPM) : Only one channel is busy
Flash (120 IPM): 2 through 10 channels are busy
PRT (T1)
PRT (E1)
×
×
×
×
×
×
×
×
×
–
×
×
FUNCTION
: More than 10 channels are busy
: All channels are idle
LAMP
MRMT
RMT
CRC
AIS
BL
– 277 –
PN-DTB (PRT)
×: Used –: Not used
PRT (T1)
PRT (E1)
×
–
×
×
×
–
×
×
×
×
NWA-008852-001 Rev.5.0
JULY/13/2007
98ch4002.fm