Table of Contents
Advertisement
A
CMAA
Assign the ISDN Protocol Type for DCH cir-
cuit on the BRT card.
CM07
Assign an ISDN trunk number to each Channel
number of BRT.
NOTE:
Be sure to assign the trunk numbers
to all circuits (00-03 of the 2BRT
card, 00-07 of the 4BRT card), even
if only one PCM digital line is ac-
commodated to the 2BRT card or
less than four PCM digital lines are
accommodated to the 4BRT card.
Set make-busy to the unused trunk
numbers by CME5 Y=1, 2nd da-
ta=0.
B
DESCRIPTION
BRT INITIAL
INITIAL
CHAPTER 3 SYSTEM DATA PROGRAMMING
•
Y=06
(1)
04-15, 20-31: AP No. of BRT assigned by
(2)
ISDN Protocol Type
17 : Australia
18 : New Zealand
20 : AT&T (#4, #5 ESS)
21 : NTI (DMS 100, 250)
22 : Australia ETSI
24 : ETSI Standard
(Brazil, Columbia, Indonesia, UAE)
25 : ITU-T Standard (Thailand)
27 : USA NI-1
28 : USA NI-2
31 : Germany
[Series 3200 R6.2 software required]
[For EU]
32 : Netherlands
[Series 3200 R6.2 software re-
quired]/
Greece/Luxembourg/Portugal/Spain/
Sweden
[Series 3500 software required]
[For EU]
33 : Italy
[Series 3200 R6.2 software required]
[For EU]
63 : Not used
•
Y=02
(1)
XX ZZ
XX: 04-15, 20-31: AP No. assigned by
ZZ : B channel No. (00/01: BRT)
(2)
D000-D255: Trunk No.
– 187 –
EVENT BASED CCIS PROGRAMMING
DATA
CM05
CM05
(00-03: 2BRT)
(00-07: 4BRT)
Trunk No. already assigned
by CM10/CM14 cannot to be
used.
NWA-008852-001 Rev.5.0
NOVEMBER/15/2006
98ch3002.fm
Advertisement
Table of Contents
