Point-To-Multipoint Connection - Philips SOPHO 2000 IPS User Manual

Point-to-Multipoint Connection

• Short Passive Bus
• Extended Passive Bus
Maximum 164 ft. (50 m)
START
CMAC Assign the point-to-multipoint connection as
the Layer 2 data link.
Specify the passive bus.
CM1B Assign an ISDN Terminal Multipoint station
number to the ISDN Line station number.
The numbers assigned in this command are
station numbers that are to be programmed in
the BRI terminal. CM12 Y=12 will use the sta-
tion assignment from CM10/CM14.
END
407
ISDN Terminal
417 410
Maximum 1310 ft. (400 m)
DESCRIPTION
CHAPTER 3 SYSTEM DATA PROGRAMMING
MDF
ISDN Terminal
400
Maximum 491 ft. (150 m)
MDF
• Y=01
(1) XX Z
XX: 00-15: ICH No.
INITIAL
Z : 0-7: ISDN Line No. of ICH card
: 0-1: ISDN Line No. of ILC
(2) 1 : Point-to-Multipoint Connection
• Y=03
(1) XX Z
INITIAL
XX: 00-15: ICH No.
Z : 0-7: ISDN Line No. of ICH card
: 0-1: ISDN Line No. of ILC
(2) 0 : Extended Passive Bus
1 : Short Passive Bus
(1) XXXXXXXX
XXXXXXXX: ISDN Line Station No. as-
Z: 0-7: ISDN Multipoint No.
(2) X-XXXXXXXX: ISDN Terminal Multi-
– 172 –
ISDN TERMINAL DATA PROGRAMMING
ILC
300
ILC
301
DATA
(PN-2ILCC) card
(PN-2ILCC) card
,
Z
signed by CM10/CM14
point Station No.
NWA-008852-001 Rev.5.0
SEPTEMBER/15/2006
PBX
98ch3002.fm