Table of Contents
Advertisement
E
CM35
Specify whether the ISDN trunk is released
when the system receives ISDN DISCON-
NECT message with Progress Description=08
from ISDN (effective for an outgoing call).
[Series 3200 R6.2 software required]
NOTE:
When sending the in-band tone to
the calling station from ISDN, set
the second data to 1.
In this case, the ISDN trunk will be
released automatically in 30 sec-
onds after the calling station re-
ceives the in-band tone or when the
calling station goes on-hook.
Assign the method of Terminal Endpoint Iden-
tifier (TEI) assignments for the Trunk number.
[Series 3800 software required]
NOTE:
Automatic TEI assignment (set the
second data to 0) is available only
when second data of CM35 Y=79 is
set to 1 (Point-to-Multipoint con-
nection).
Specify whether the ISDN trunk is released
when the system receives ISDN DISCON-
NECT message with Progress Description=08
from ISDN (effective for an incoming call).
[Series 3200 R6.2 software required]
NOTE:
When sending the in-band tone to
the called station from ISDN, set the
second data to 0.
In this case, the ISDN trunk will be
released automatically in 30 sec-
onds after the called station receives
the in-band tone or when the called
station goes on-hook.
F
DESCRIPTION
BRT INITIAL
CHAPTER 3 SYSTEM DATA PROGRAMMING
•
Y=158
(1)
00-63: B channel Trunk Route No.
(2)
0 : To release
1 : Not released
•
Y=283
(1)
00-63: B channel Trunk Route No.
(2)
0 : Automatic TEI Assignment
(TEI: 64-126)
1 : Non-Automatic TEI Assignment
(TEI: 0 fixed)
•
Y=208
(1)
00-63: B channel Trunk Route No.
(2)
0 : Not released
1 : To release
– 191 –
EVENT BASED CCIS PROGRAMMING
DATA
NWA-008852-001 Rev.5.0
NOVEMBER/15/2006
98ch3002.fm
Advertisement
Table of Contents
