Download Print this page

Philips SOPHO 2000 IPS User Manual page 254

Hide thumbs Also See for SOPHO 2000 IPS:

Table of Contents

Set the groove on the switch to the desired position.

When the power is on, flip the MB switch to ON (UP position) before plugging/unplugging the

circuit card.

The system can receive clock signals from two clock supply routes.

In normal condition, the system synchronizes to the clock signals supplied on the PLO0 of MP

card via the Back Wiring Board, and if the clock signals are failed, the clock supply route takes

over to PLO1 automatically. Set SW4-1 to SW4-5 as follows.

When one BRT is

When more than

one BRT is pro-

Mount the BRT card which receives a source clock signals into PIM0.

PN-4BRTA-A (BRT)

NWA-008852-001 Rev.5.0