Table of Contents
Advertisement
For providing the Calling Party Name for outgoing call to the network, do the following programming.
[North America]
[Series 3600 software required]
NOTE 1:
This feature is available only when the 24PRT card is used.
NOTE 2:
This programming is effective when ISDN Protocol type is assigned to 28 (National ISDN-2
[NI-2]) by CMAA Y=06.
START
CM77
Assign the Calling Party Name to each stations
with character code/character.
NOTE:
CM12
Assign Service Restriction Class B to each sta-
tion.
CM15
Allow Calling Party Name sending to ISDN.
CM35
Provide the Calling Party Name sending to
ISDN.
CM08
Assign the Calling Party Name sending to
ISDN when making an outgoing call from Sub
Line.
END
Page 102
DESCRIPTION
The characters available for assign-
ing are 0-9, A-Z with MAT/CAT.
CHAPTER 3 SYSTEM DATA PROGRAMMING
•
Y=0
(1)
X-XXXXXXXX: Station No.
(2)
20-7F: Calling Party Name Character Code
(Maximum 32 digits)
See Command Manual.
•
Y=1
(1)
X-XXXXXXXX: Station No.
(2)
XX...XX: Calling Party Name Character
•
Y=02
(1)
X-XXXXXXXX: Station No.
(2)
XX ZZ
ZZ: 00-15 : Service Restriction Class B
•
Y=156
(1)
00-15: Service Restriction Class B assigned
by CM12 Y=02
(2)
1 : Allow
•
Y=268
(1)
00-63: B channel Trunk Route No.
(2)
0: To provide
(1)
502
(2)
0 : Name of My Line
1 : Name of Sub Line
– 127 –
ISDN FEATURE PROGRAMMING
DATA
(Maximum 16 characters)
NWA-008852-001 Rev.5.0
98ch3001.fm
NOVEMBER/15/2006
NOTE
Advertisement
Table of Contents
