Philips SOPHO 2000 IPS User Manual page 304

SWITCH NAME
JP1 (Jumper pin)
JP2 (Jumper pin)
JP3 (Jumper pin)
JPRI (Jumper pin)
JPR (Jumper pin)
JPT (Jumper pin)
The figure in the SWITCH NAME column and the position of
umn indicate the standard setting of the switch. When the switch is not set as shown by the figure and
, the setting of the switch varies with the system concerned.
NOTE 1: Set the groove on the switch to the desired position.
NOTE 2:
When the power is on, flip the MB switch to ON (UP position) before plugging/unplugging the
circuit card.
SWITCH SETTING
NUMBER POSITION
RIGHT
LEFT
RIGHT
LEFT
LEFT
LEFT
FUNCTION
Not used
Not used
Not used
Not used
Not used
Not used
– 290 –
PN-DTA (CCH)
in the SETTING POSITION col-
Continued on next page
NWA-008852-001 Rev.5.0
CHECK
98ch4002.fm
JULY/13/2007