Table of Contents
Advertisement
Mounting CONN Card
When providing CONN (PZ-M542/PZ-M557) card to connect a coaxial cable for DTI/PRT, do the follow-
ing installation.
(1)
Confirm the correct switch settings of the CONN card. See CHAPTER 4.
Page 305
(2)
Connect the CONN card to LTC connector on BWB in the PIM which accommodates DTI/PRT cards
as shown below.
STEP1: When using LTC0 or LTC2 connector to mount the PZ-M542/PZ-M557 card, take off the
PLATE from the PZ-M542/PZ-M557 card. Then, overturn the PLATE and secure it to the card
with screws.
When using LTC1 or LTC3 connector to mount the PZ-M542/PZ-M557 card, skip STEP1.
NOTE:
The PLATE and screws are attached to the PZ-M542/PZ-M557 card.
Connection of PZ-M542/PZ-M557 and PLATE
PLATE
PZ-M542/PZ-M557
SCREW
INSTALLATION PROCEDURE FOR ISDN-PRI
– 54 –
CHAPTER 2 INSTALLATION
Page 303,
NWA-008852-001 Rev.5.0
98ch2001.fm
Advertisement
Table of Contents
