Philips SOPHO 2000 IPS User Manual page 295

SWITCH NAME
JPRI (Jumper pin)
JPR (Jumper pin)
JPT (Jumper pin)
The figure in the SWITCH NAME column and the position of
umn indicate the standard setting of the switch. When the switch is not set as shown by the figure and
, the setting of the switch varies with the system concerned.
NOTE 1: Set the groove on the switch to the desired position.
NOTE 2:
When the power is on, flip the MB switch to ON (UP position) before plugging/unplugging the
circuit card.
NOTE 3: When accommodating the PRT card in Remote Site with AP numbers 64-93 (for the expanded
PRT card), be sure to set the switch number of all the PRT cards accommodated with the SENSE
switch/SW1-4 to 31, and to assign any one number from AP numbers 64-93 with CM05 per PRT
card (same even if the site that accommodates the PRT card is different).
SWITCH SETTING
NUMBER POSITION
LEFT
RIGHT
LEFT
RIGHT
LEFT
FUNCTION
Not used
Neutral grounding on the receiving line
is provided
Neutral grounding on the receiving line
is not provided
Neutral grounding on the transmitting
line is provided
Neutral grounding on the transmitting
line is not provided
– 281 –
PN-DTB (PRT)
in the SETTING POSITION col-
Continued on next page
NWA-008852-001 Rev.5.0
CHECK
98ch4002.fm
JULY/13/2007