Table of Contents
Advertisement
HOW TO READ THIS CHAPTER
In the programming procedure, the meanings of (1), (2) and markings are as follows.
(1)
:
1st Data
(2)
:
2nd Data
:
Initial Data
With the system data clear command (CM00, CM01), the data with this marking is automat-
ically assigned for each command.
:
INITIAL
DTI INITIAL
:
DCH INITIAL
:
BRT INITIAL
:
ICH INITIAL
:
OFF LINE
:
System Initialization
A reset of the MP card is required after data setting.
Press SW1 switch on the MP card.
DTI Initialization
A reset of the DTI/PRT card is required after data setting.
Set the Make Busy switch to UP and then Down.
DCH Initialization
A reset of the DCH card is required after data setting.
Set the Make Busy switch to UP and then Down.
BRT Initialization
A reset of the BRT card is required after data setting.
Set the Make Busy switch to UP and then Down.
ICH Initialization
A reset of the ICH card is required after data setting.
Set the Make Busy switch to UP and then Down.
Off Line
Command with this marking can be used only under Off-Line mode of the MP
card.
To set Off-Line mode,
(1) Set SW3 on the MP card to "2" or "3".
(2) Press SW1 on the MP card.
CHAPTER 3 SYSTEM DATA PROGRAMMING
– 82 –
HOW TO READ THIS CHAPTER
NWA-008852-001 Rev.5.0
98ch3001.fm
Advertisement
Table of Contents
