Station Message Detail Recording - NEC SL1100 Features And Specifications Manual

ISSUE 2.0
Related Features
Abbreviated Dialing/Speed Dial
Automatic Route Selection (ARS/F-Route)
PBX Compatibility/Behind PBX

Station Message Detail Recording

Guide to Feature Programming
The programs listed below indicate the most commonly used programs required for this feature. The
programs are listed in the order that the installer should follow. Refer to the PCPro wizards for further
detailed programming.
• When a * is listed next to the Program Number it indicates a program that MUST be set (from a
default state) for this feature to be enabled.
Program
Number
35-05-01 * Account Code Mode
Per class of service (PRG 20-06-01) this program is used to setup the
account code mode.
For Forced Account codes, options 2 or 3 will be the settings that are
used.
35-05-02 Forced Account Code Toll Call Setup
Per class of service (PRG 20-06-01) this program is used to enable
account codes for ALL calls or just TOLL calls if PRG 35-05-01 is set
to a 2 or 3.
35-05-03 Account Codes for Incoming Calls
Per class of service (PRG 20-06-01) this program is used to allow or
deny users the ability to enter an account code for incoming calls.
Account codes for incoming calls are used in conjunction with SMDR
for billing purposes.
35-05-04 Hiding Account Codes
Per class of service (PRG 20-06-01) this program is used to either
hide or show the account code entered on the users display.
When set to hide the account code the users display will show a
every digit dialed instead of displaying the actual digit.
35-06-01 Verified Account Code Table
If PRG 35-05-01 is set to a (3), required and verified, this is where the
verified account code list is created in the system.
Up to 800 account codes with 1 ~ 16 digits can be entered.
Wild cards can be entered by using the @ symbol. For example @234
means the user can enter 0234 ~ 9234 as valid account codes.
*
The digit cannot be used in the account code because this digit is
used to start and end the account code entry.
40-10-01 VRS Fixed Message
Enable or Disable the system's ability to play the fixed VRS messag-
es.
When enabled the system will play the following message "please en-
ter you account code" when the user is required to enter an account
code.
Features and Specifications Manual
Program Name/Description Assigned Data
0 = Account Codes Disabled
1 = Account Codes Optional (This
is for the account code entry feature.)
2 = Account Code Required Not
Verified (Forced Account Codes ena-
bled, no verification with the system
required)
3 = Account Code Required and
Verified (Forced Account Codes ena-
bled, verification with PRG 35-06-01
required)
(default = 0)
0 = Account Codes for ALL calls
1 = Account Codes for TOLL calls
(default = 0)
0 = Disabled (User cannot enter an
account code.)
1 = Enabled (User can enter an ac-
count code while on an incoming
call.)
(default = 0)
0 = Account Codes Displayed
1 = Account Codes Not Displayed
(default = 0)
* for
Maximum of 16 digits (0~9, #, @)
(default =Not Assigned)
0 = Disable (VRS fixed message will
not be played.)
1 = Enable (VRS fixed message will
be played.)
(default = 0)
SL1100
A
1-15