NEC SL1100 Features And Specifications Manual page 134

SL1100
Related Features
Abbreviated Dialing/Speed Dial
Automatic Route Selection (ARS/F-Route)
Call Arrival (CAR) Keys
Caller ID Call Return
Conference, Voice Call/Privacy Release
Park
Station Message Detail Recording
C
InMail
Guide to Feature Programming
The programs listed below indicate the most commonly used programs required for this feature. The
programs are listed in the order that the installer should follow. Refer to the PCPro wizards for further
detailed programming.
• When a * is listed next to the Program Number it indicates a program that MUST be set (from a
default state) for this feature to be enabled.
Program
Number
20-09-02 *
14-02-10 *
15-03-09
14-01-22
14-01-24
20-02-08
1-122
Program Name/Description
Caller ID Display
Per Class of service this command enables or disables the ability to
display the caller ID name/number received from the Telco.
Analog Caller ID
On a per analog trunk basis caller ID can be enabled or disabled.
This command is only for Analog trunks and should never be enabled
for T1, PRI, or SIP trunks.
Caller ID Function - for External Module
This command enables or disables a Single Line Terminal with a dis-
play to show the caller ID received from the Telco.
This program is only for Single Line Terminals (not digital or IP) that
have caller ID displays. If the phone does not have a caller ID display,
do not enable this.
Caller ID to Voice Mail
This command enables or disables the ability for the system to send
the caller ID information to the Voice Mail.
This command is for ALL trunk types (analog, digital, and IP).
Trunk to Trunk Outgoing Caller ID through Mode
This command is for PRI and SIP trunks only and should never be en-
abled on any other trunk type.
When this command is enabled the system will pass the originating
callers caller ID on to the Telco if the call is forwarded out of the sys-
tem.
Some Telco offices do not support this and will replace the number
you send them with the main billing number.
LCD Holding Time
This command specifies the amount of time a user's display shows
caller ID for a second incoming call.
ISSUE 2.0
Assigned Data
0 = Off (Caller ID not displayed.)
1 = On (Caller ID is displayed.)
(default = 0)
0 = Off (Caller ID not displayed.)
1 = On ( Caller ID is displayed.)
(default = 0)
0 = Disable (Caller ID not displayed.)
1 = Enable (Caller ID is displayed.)
(default = 0)
0 = Disable (Caller ID not sent to
VM.)
1 = Enable (Caller ID is sent to VM.)
(default = 0)
0 = Disable (Caller ID not forwarded
out.)
1 = Enable (Caller ID is forwarded
out.)
(default = 0)
0 ~ 64800 seconds
(default = 5 seconds)
Caller ID