Centralized Voice Mail - NEC SL1100 Features And Specifications Manual

ISSUE 2.0
Program Num-
ber
22-11-06 DID Translation Table Number Conversion - Transfer Des-
tination Number 2
SL Net allows calls to overflow to a Centralized Voice Mail
from any location using a setting data of 103. When 103 is as-
signed, calls will overflow to the pilot number defined in PRG
45-01-07.
If the transfer operation mode is set (PRG 22-11-04), and one
of the conditions is met, calls will overflow from the target num-
ber to the destination in this program. If this was a No Answer
condition, calls would overflow to this program after the timer
in PRG 22-01-06 expires.
22-12-01 DID Intercept Ring Group
If the transfer operation mode is set (PRG 22-11-04), and the
call has overflowed through Transfer Destination Number 1
and 2, and Incoming Ring Group Transfer is enabled, calls will
be routed to the destination in this program.
SL Net allows calls to overflow to a Centralized Voice Mail
from any location using a setting data of 103. When 103 is as-
signed, calls will overflow to the pilot number defined in PRG
45-01-07.

Centralized Voice Mail

Program Num-
ber
11-07-01 Department Group Pilot Number
Assign the Voice Mail pilot number to the group that is to be
used. A pilot number must fall within the valid numbering plan
assigned in PRG 11-01-01.
NEC recommends that you do not use department group 01
because by default all extensions are assigned to this group.
This program is only assigned in the system that has the Voice
Mail.
14-01-22 Caller ID to Voice Mail
This command enables or disables the ability for the system to
send the caller ID information to the Voice Mail.
This command is for ALL trunk types (analog, digital, and IP).
*1 SLT Signaling Type
15-03-01
Assign all extension numbers to be used for Voice Mail to a
signaling type of DP.
*1 Terminal Type
15-03-03
Assign all extension numbers to be used for Voice Mail to a
terminal type of Special.
If the ports are left assigned as normal, the Voice Mail will not
be able to receive DTMF tones.
Features and Specifications Manual
Program Name
Program Name
SL1100
Default
0 = No setting
1 ~ 25 = Ring Group 1 ~ 25
102 = Voice Mail (Call goes to the VM
pilot assigned in PRG 45-01-01)
103 Centralized Voice Mail (if central-
ized VM is enabled this setting is used
to route calls to the VM)
201 ~ 232 = Department Group 1 ~ 32
401 = DISA
501 ~ 599 = DISA/VRS Message (VRS
message number 1 ~ 99)
1000 ~ 1999 = Speed Dial Bins 000 ~
999
(default)
0
0 = No setting
1 ~ 25 = Ring Group 1 ~ 25
102 = Voice Mail (Call goes to the VM
pilot assigned in PRG 45-01-01)
103 Centralized Voice Mail (if central-
ized VM is enabled this setting is used
to route calls to the VM)
(default)
1
Default
Maximum of 8 digits (0 ~ 9, *, #,)
(default)
not assigned
0 = Disable (Caller ID not sent to VM)
1 = Enable (Caller ID is sent to VM)
(default)
0
0 = DP
1 = DTMF
(default)
1
0 = Normal
1 = Special
(default)
0
S
1-691