NEC SL1100 Features And Specifications Manual page 477

ISSUE 2.0
Fractional PRI
Program
Number
10-39-01 * Fractional Setup
This program is used to enable/disable the SL1100's ability to use a
fractional PRI or T1.
10-03-21 * Number of Ports
This program assigns the number or ports to the PRI card when PRG
10-39-01 is set to a 1 (fractional enabled).
After this program is changed the PRI card must be reset before the
system will assign trunks to the PRI.
Calling Party Number Presentation (CPN)
Program
Number
20-08-13 * ISDN CLIP
This program enables/disables the ability to send calling party number
information per class of service.
21-12-01 * ISDN CPN setup for Trunks
This program is used to assign a calling party number per trunk.
If CPN information is programmed on both the trunk and station when
a call is made the CPN from the station will be sent to the Telco.
21-13-01 * ISDN CPN setup for Stations
This program is used to assign a calling party number per station.
If CPN information is programmed on both the trunk and station when
a call is made the CPN from the station will be sent to the Telco.
10-03-05 ISDN Clip Information
This program allows/denies the sending of calling party number infor-
mation per PRI.
15-01-04 ISDN Caller ID
This program allows/denies the sending of calling party number infor-
mation per station.
15-07-01 Programmable Function Keys
This program is used on a per station basis to assign different function
keys to the Multiline Terminals.
Function key (63) is used to temporarily block the station from sending
CPN information. When the key is pressed it will light up red and while
the key is lit any calls from that station will not send CPN information
to the Telco.
Features and Specifications Manual
Program Name/Description
Program Name/Description
SL1100
Assigned Data
0 = Disable (when disabled the sys-
tem will assign the PRI as a full PRI
and use 24 trunks.)
1 = Enable (when enabled the sys-
tem will not assign any trunks to the
PRI, the trunks must be manually
configured.)
(default = 0)
0 = Automatic
1 = 4 Ports
2 = 8 Ports
3 = 12 Ports
4 = 16 Ports
5 = 20 Ports
(default = 0)
Assigned Data
0 = Off (when set to Off the system
will not send any outbound calling
party information.)
1 = On (when set to ON the system
will send calling party information for
the station or trunk.)
(default = 0)
Maximum of 16 digits (0 ~ 9, *
Most Telco's will only accept 10
digits.
(default = Not Assigned)
*
Maximum of 16 digits (0 ~ 9,
Most Telco's will only accept 10
digits.
(default = Not Assigned)
0 = NO (CPN is NOT sent.)
1 = YES (CPN is sent.)
(default = 1)
0 = Disabled (CPN is NOT sent.)
1 = Enabled (CPN is sent.)
(default = 1)
63 = Outgoing Call Without Caller
ID
(Refer to the programming manual for
the default values and for all other
available options in this command.)
1-465
I
, #)
, #)