Voice/Melody Ringing By Vm; Table 1-71 Wav Format - NEC SL1100 Features And Specifications Manual

ISSUE 2.0
Description
This feature enables to play the pre-recorded WAV data (voice or melodies...) instead of ringing tone
to indicate incoming trunk call. It is possible to ring to play the WAV file (address to VM) for each
Caller-ID basis or each ring extension basis, and can be identified to know before answer the call. The
feature also plays Voice/Melody to each ringing Multiline Terminal Extension instead of Caller-ID.
Audio Prompt Format
In order for uploaded greetings to properly play on the SL1100 they must be in the proper format.
Audio files not recorded in the proper format may not playback. The proper format is:
Item
Bit Rate
Sampling Size
Channel
Sampling Rate
Audio Format
Size
Length
To upload the WAV file to the system please refer to
Conditions
• The feature basically work with Normal Trunk Incoming call, PBX, CES Incoming Call, DID/DISA/
VRS, DID/DDI and Dial-In in the Tie Line.
• The feature does not work for Internal Incoming Call, Virtual extension ring, Door Box ring, Callback,
Alarm, VRS Waiting Message incoming call.
• This feature is applicable only for Digital Multiline Terminal. Analog phone and IP Phone is not
applicable this feature.
• If all the VRS channels are busy, the normal incoming ring tone takes place.
• The feature works when the Multiline Terminal is idle.
• The feature works during play BGM or Room Monitor.
Features and Specifications Manual

Voice/Melody Ringing by VM

Table 1-71 WAV Format

64 kbps
8 bits
1 (Mono)
8 kHz
CCiTT μ-law
1 MB
2 Min.
InMail Upload Download Audio on page
Specification
SL1100
V
1-412.
1-789