NEC SL1100 Features And Specifications Manual page 683

ISSUE 2.0
Program
Number
20-03-05 System Options for Single Line Telephones - SLT
Operation Mode
20-03-06 System Options for Single Line Telephones -
Headset Ringing Start Time
20-03-07 System Options for Single Line Telephones -
Trunk Call Dial Forced Sending Start Time (Forced
Dial)
20-06-01 Class of Service for Extensions
20-13-13 Class of Service Options (Supplementary Service)
- Continued Dialing (DTMF) Signal on ICM Call
20-15-01 Ring Cycle Setup - Normal Incoming Call on Trunk
20-15-03 Ring Cycle Setup - Incoming Internal Call
20-15-05 Ring Cycle Setup - DID/DDI
80-03-01 DTMF Tone Receiver Setup - Detect Level
80-03-02 DTMF Tone Receiver Setup - Start delay time
80-03-03 DTMF Tone Receiver Setup - Min. detect level
80-03-04 DTMF Tone Receiver Setup - Max. detect level
80-03-05 DTMF Tone Receiver Setup - Forward twist level
80-03-06 DTMF Tone Receiver Setup - Backward twist level
80-03-07 DTMF Tone Receiver Setup - ON detect time
80-03-08 DTMF Tone Receiver Setup - OFF detect time
80-04-01 Call Progress Tone Detector Setup - Detection
Level
80-04-04 Call Progress Tone Detector Setup - No tone time
Operation
Refer to the individual features listed in the Related Features section above in this feature.
Features and Specifications Manual
Program Name Default
0
5 (seconds)
0 (seconds)
Extension 101 is Class 15 and other
Extension are Class 1
COS 01~15 = 1
3
12
8
Type 1~5 = 0
Type 1~5 = 0
Type 1 = 10 (-20dBm)
Type 2 = 15 (-25dBm)
Type 3 = 15 (-25dBm)
Type 4 = 10 (-20dBm)
Type 5 = 10 (-20dBm)
2 (-2dBm)
Type 1 ~ 5 = 5 (6dBm)
Type 1 ~ 5 = 0 (1dBm)
Type 1 = 1 (30ms)
Type 2 = 1 (30ms)
Type 3 = 1 (30ms)
Type 4 = 1 (30ms)
Type 5 = 1 (30ms)
Type 1 = 1 (30ms)
Type 2 = 1 (30ms)
Type 3 = 1 (30ms)
Type 4 = 1 (30ms)
Type 5 = 1 (30ms)
Type 1 (DT) = 0 (-25dBm)
Type 2 (BT) = 0 (-25dBm)
Type 3 (RBT) = 0 (-25dBm)
Type 4 = 0
Type 5 = 0
Type 1 (DT) = 132 (3990ms)
Type 2 (BT) = 132 (3990ms)
Type 3 (RBT) = 132 (3990ms)
Type 4 = 0
Type 5 = 0
SL1100
Note
S
1-671