NEC SL1100 Features And Specifications Manual page 478

SL1100
Calling Party Name Presentation
Program
Number
20-08-13 * ISDN CLIP
This program enables/disables the ability to send calling party name/
number information per class of service.
14-01-36 * Calling Party Name Notification - Per trunk
This program enables/disabled the ability to send calling party name
information on a per trunk basis.
I
15-01-10 * Calling Party Name Notification - Per station
This program enables/disables the ability to send calling party name
information on a per station basis.
15-01-01 * Extension Name
This program allows on a per station basis for a name to be program-
med.
This is the name that will be sent out to the Telco unless PRG
20-19-09 (system calling party name) is set. If a name is programmed
in PRG 20-19-09 it will take precedence over any setting in PRG
15-01-01.
20-19-09 System Calling Party Name
When a name is programmed in this program this will be the name
sent out for all callers that have PRG 15-01-10 enabled.
10-03-05 ISDN Clip Information
This program allows/denies the sending of calling party name/number
information per PRI.
15-01-04 ISDN Caller ID
This program allows/denies the sending of calling party name / num-
ber information per station.
15-07-01 Programmable Function Keys
This program is used on a per station basis to assign different function
keys to the Multiline Terminals.
Function key (63) is used to temporarily block the station from sending
CPN information. When the key is pressed it will light up red and while
the key is lit any calls from that station will not send CPN information
to the Telco.
DDI Mode Switching
Program
Number
10-03-20 ISDN Protocol Selection
Assign the protocol that is to be used for the ISDN service.
The setting in the SL1100 MUST match the setting that the Telco has
configured.
1-466
Program Name/Description
Program Name/Description
ISSUE 2.0
Assigned Data
0 = Off (when set to Off the system
will not send any outbound calling
party information.)
1 = On (when set to ON the system
will send calling party information for
the station or trunk.)
(default = 0)
0 = Off (when set to Off the system
will not send any outbound calling
party information.)
1 = On (when set to ON the system
will send calling party information.)
(default = 0)
0 = Off (when set to Off the system
will not send any outbound calling
party information.)
1 = On (when set to ON the system
will send calling party information.)
(default = 0)
*
Maximum of 12 digits (0 ~ 9,
(default = Not Assigned)
Maximum of 12 digits (0 ~ 9, *
(default = Not Assigned)
0 = NO (CPN is NOT sent.)
1 = YES (CPN is sent.)
(default = 1)
0 = Disabled (CPN is NOT sent.)
1 = Enabled (CPN is sent.)
(default = 1)
63 = Outgoing Call Without Caller
ID
(Refer to the programming manual for
the default values and for all other
available options in this command.)
Assigned Data
0 = Standard
3 = DMS (A211)
4 = 5ESS
5 = DMS (A233)
6 = 4ESS
7 = NI2
(default = 7)
ISDN Compatibility
, #)
, #)