Network Camera Setting Values - Panasonic BB-HNP17A Operating Instructions Manual

4.2 Network Camera Setting Values

4.2 Network Camera Setting Values
When registering cameras, performing settings changes after registration, or accessing cameras when the
auto settings of the camera are enabled, settings on the cameras are changed in the following manner.
Image Image capture size (MPEG-4/H.264)
Image quality (JPEG)
Image quality (MPEG-4/H.264)
Sending Mode (MPEG-4/H.264)
Frame rate (MPEG-4/H.264)
Max bit rate (per client) (MPEG-4)
Max bit rate (per client) (H.264)
Refresh interval (MPEG-4/H.264)
alarm alarm Setting
Motion detection area
Address 1 of Destination of notification
Destination Port Number
Audio Audio transmission/reception
Audio bit rate
Audio encoding format
Transmission interval
Note
•
This program will automatically be set up when the auto settings of the camera are enabled, so please
do not change the settings directly on the camera.
•
These setting values are necessary when using cameras registered to the software. Do not change
the values directly on cameras.
•
When the auto settings of the camera are disabled, the settings need to be configured directly on the
camera. Please make sure to run [Check the Camera Function] after configuring the settings on the
camera. The camera may not function correctly if the check is not performed.
164 Operating Instructions
Network camera recorder software's setting
value.
Network camera recorder software's setting
value.
Normal
Frame rate
Network camera recorder software's setting
value.
Network camera recorder software's setting
value.
Network camera recorder software's setting
value.
1 second
Terminal 1: Alarm Input
Terminal 2: Alarm Input
Terminal 3: AUX Output
The whole area of the area 1
The IP address of the PC that performed
[Check the Camera Function].
1818
Interactive
•
[Mic input] is used when for cameras
that have no audio transmission
functions.
32 kbps
G.726
640ms