Table of Contents
Advertisement
Setting
Authentication Method
SSL
Image Attachment Resolution
(Width)
Note
•
After completing settings, click [Sending Test], and confirm that the message arrives at the specified
destination.
•
[Number of Waiting Messages] shows the number of messages waiting to be set.
Up to 100 waiting messages can be saved.
Click [Delete] to delete the waiting messages.
Deleted messages will not be sent.
•
To send notification messages when events are detected, select [Forward] in each event detection's
settings page. (® Page 32, Page 36, Page 40, Page 42)
•
Images captured by event detection (Motion Detection, Alarm Detection, Sensor Detection, Sound
Detection, and Shock Detection) are sent with messages.
Set the authentication method required by your Internet Service Providers
(ISP) as necessary.
•
No Authentication: Select this option if user authentication is not
required.
•
POP before SMTP Authentication: Depending on the ISP, POP before
SMTP Authentication may be necessary. If so, select [POP before
SMTP Authentication] and set each parameter.
–
IP Address or Host Name: Enter the POP3 Server IP address or host
name. IPv6 addresses can also be used.
[Space], ["], ['], [&], [<], [>], [0.0.0.0], and [255.255.255.255] cannot
be entered.
–
Port: Enter the port number (1-65535). Port 110 is normally used.
–
Login ID: Enter the POP3 login ID (user name) in English one-byte
characters (63 characters or less).
["] cannot be entered.
–
Password: Enter the POP3 password in English one-byte characters
(63 characters or less).
["] cannot be entered.
•
SMTP Authentication: User authentication is performed by the Mail
Sending Server (SMTP). Your ISP must be SMTP Authentication
compatible.
3 types of authentication methods are supported: PLAIN, LOGIN, and
CRAM-MD5.
–
Login ID: Enter the Mail Sending Server (SMTP) Login ID (user
name) in English one-byte characters (63 characters or less).
["] cannot be entered.
–
Password: Enter the Mail Sending Server (SMTP) password in
English one-byte characters (63 or less characters).
["] cannot be entered.
Select [Use] if you want to use SSL encryption when sending E-mail.
•
When [Use] is selected, the SMTP port number may need to be set to
465. Ask your ISP or network administrator for the appropriate settings.
•
SSL supports SMTP over SSL., STARTTLS is not supported.
Set the resolution (width) of images to be sent as E-mail attachments.
(640, 320 (default), 160)
•
The resolution (height) of the image attachment corresponds to the
resolution setting of the camera.
1.5.3 Setting E-mail notification
Description
Operating Instructions
21
Advertisement
Table of Contents
