Table of Contents
Advertisement
2.7 Changing computers
•
This function is installed in Ver. 4.05 or a later version of this program.
(If your current version is older, you can use this function by updating to Ver. 4.05 or later versions of this
program.)
•
One hard disk drive connected by USB is required as the save file destination.
Diagram
PC-A: The PC used to operate this program up until now
PC-B: The PC used to operate this program from now on
Save file destination of PC-A: Use an external USB hard disk, assigned to the E drive (E:\ncrdata)
PC-A
C drive (*1)
BB-HNP17
Operating procedure of PC-A
1.
Close this program (® Page 10)
2.
Uninstall this program
3.
Shut down Windows
4.
Disconnect from the network by removing the LAN cable
5.
Disconnect the save file destination hard disk
Operating procedure of PC-B
1.
Connect to the network by connecting a LAN cable
2.
Start up Windows
3.
Connect the save file destination hard disk and assign it as the E drive
4.
Install this program
Please select the same drive and folder for PC-A and PC-B for the installation location. (The C drive is used in this example.)
*1
Please select the same drive letter for the save file destination hard disk for PC-A and PC-B. (The E drive is used in this example.)
*2
Start up this program
1.
Set the save file destination to E:\ncrdata
* When using the settings of the previous PC-A as they were, do not register the camera
2.
When clicking [Yes] after the dialog is displayed to import the configuration file located in the destination
folder of the hard disk, the camera information and recording information will be automatically imported.
The importing is finished after the program automatically reboots.
Camera
E drive (*2)
Save to HDD
PC-B
E drive (*2)
Save to HDD
2.7 Changing computers
C drive (*1)
BB-HNP17
Operating Instructions
99
Advertisement
Table of Contents
