Table of Contents
Advertisement
2.2 Setting Cameras
Setting
Image Popup Duration
"Beep" is a program that is installed with this software. [Beep 1000 1000] is a command that causes the computer's beep to sound
*1
at 1000 Hz for 1000 ms. The command also allows you to set up user-defined commands. However, depending on the command's
operation, recording performance may be affected. Use optional commands after thorough testing. Recorded image quality cannot
be guaranteed when using optional commands. Beep does not run on 64-bit CPU compatible versions of Windows.
When the output time of the camera's external output is set
:
Motion detection
•
Unlock the external output at the set time.
Output time
Execute Commands for Camera External Output Settings
Execute Commands for Camera External Output Unlocking
•
If detection occurs during the output time, output is extended for the time from the detection to the set
output time.
Output time
Output time
Execute Commands for Camera External Output Settings
Execute Commands for Camera External Output Unlocking
Command Execution Timing
When [Command execution timing] is not set
:
Motion detection
46
Operating Instructions
Sets the update interval of displayed pop-up images (® Page 35) when
detection is made.
•
Continue till the next new pop-up. (default)
The detection image will be displayed as a pop-up until the next
detection.
•
Specified time
Designates the display time of pop-up displays of detected images.
Pop-up displays of detected images are not updated between the
designated times.
:
Alarm detection
Output time
Output time
Output time
:
Alarm detection
Description
:
Recorded Image
:
Recorded Image
Advertisement
Table of Contents
