Rom Version Display Menu (M30); Serial Number Display Menu (M31) - Sony BVW-55 Maintenance Manual

3-4. OTHERS CHECK Mode (M3)

3-4-2. ROM VERSION Display Menu (M30)

3-4-3. SERIAL NUMBER Display Menu (M31)

3-4-2. ROM VERSION Display Menu (M30)
This menu displays the model name of this unit, the
destination and the ROM version.
M3:OTHERS
M30:ROM VERSION
1
*
BVW-55(UC)
SYS V1.00 SV1 V1.00
2
Description of LCD monitor
1 The model name of this unit and the destination in
parentheses are displayed on the LCD monitor.
The model name and destination are detected from the
setting condition of the DIP switch (S202) on the SY-
272 board.
2 Each version number of a system control ROM (SYS)
and a VTR servo ROM (SV1) is displayed on the LCD
monitor.
Menu operation
Turn the JOG dial to move the * mark.
The contents of an *-marked item on the LCD monitor are
displayed in a sub LCD.
3-30
n
The display on the left is one
of the displayed examples.
3-4-3. SERIAL NUMBER Display Menu (M31)
This menu displays the serial number of this unit. When
each serial number does not coincide because of repair, it
can be set again in this menu.
M3:OTHERS
M31:SERIAL NUMBER
10001
m
. Set the serial number again after the SY-272 board or the
NV-RAM (IC112 on the SY-272 board) is replaced.
. "-----" is displayed in the state where no serial
number is set.
Serial number setting
(1) Turn the JOG dial to turn on and off the digit you want
to set.
(2) Turn the JOG dial while pressing the search button and
change the digit number.
. Message "Push SET Button" is displayed on only
the LCD monitor when the serial number is
changed.
. To cancel the setting, press the MENU button to
terminate this menu.
(3) Repeat steps (1) and (2) for each digit.
(4) Press the SET button to save the set serial number.
. Message "Saving..." is displayed on only the LCD
monitor. If no abnormality is found, the display
changes to "Save Complete" after a few seconds.
BVW-55