Sony BVW-55 Maintenance Manual page 191

A005 : RF SWITCHING POS.
This menu is used to adjust the RF switching position
automatically.
To execute the automatic adjustment
(1) Confirm that a * mark is assigned to the "AUTO"
display on the LCD monitor and press the SET button.
. In a sub LCD, "A0050" is displayed.
(2) Insert alignment tape CR2-1B.
. The adjustment is initiated when an alignment tape
is inserted. The execution time is about 15 seconds.
. Message "ADJUSTING......" is displayed on only
the LCD monitor during adjustment.
n
If the specified cassette tape is not used, the adjust-
ment cannot be properly performed even if message
"ADJUST COMPLETE" is displayed after it is
completed.
(3) Confirm the adjustment result.
. Message "ADJUST COMPLETE" is displayed on
the LCD monitor when the adjustment is completed
normally.
An alignment tape is ejected automatically.
. Message "# ADJUST INCOMPLETE #" is dis-
played on the LCD monitor when no adjustment
can be performed. The adjustment is then interrupt-
ed. Refer to the "For Automatic Adjustment
Failure" on page 2-16 when this message is dis-
played.
(4) Press the MENU button to terminate the menu.
(5) To save the adjustment data in the NV-RAM of a
servo system, execute the SAVE SERVO ADJUST
data in an A006 : NV-RAM CONTROL menu.
BVW-55 P2
Example of display and operation
LCD monitor
SERVO ADJUST
A005:RF SWITCHING POS.
*
AUTO
PG DATA:BDF5
(1) 0 [SET]
SERVO ADJUST
A005:RF SWITCHING POS.
SET
CR2-1B
ALIGNMENT TAPE
TC 00:25:00:00
PG DATA:C000
(2) 0 Insert CR2-1B
SERVO ADJUST
A005:RF SWITCHING POS.
ADJUSTING......
PG DATA:BFFF
0
SERVO ADJUST
A005:RF SWITCHING POS.
ADJUST COMPLETE
PG DATA:BDF7
(3)
0
Confirm
[MENU]
(4)
0
(5)
0
Data save
*
A006:NV-RAM CONTROL
SERVO ADJUST
A005:RF SWITCHING POS.
# ADJUST INCOMPLETE #
PG DATA:C000
When failing the automatic adjustment
2-2. TAPE Maintenance Mode (M0)
2-2-2. SERVO ADJUST Mode (A0)
Sub LCD
A0050
A005
A005
A005
2-15