Sony BVW-55 Maintenance Manual page 64

2-2. Details of Error Messages
ERROR-03 REEL TROUBLE - 3
(REEL TROUBLE)
Description: Tape slacking or tape breaking was detected in the REC or PLAY mode.
Detecting conditions: 1) When the take-up value is lower than the specified value with respect to the
2) When the tension value calculated from the supply tension sensor output is
3) When the supply reel and take-up reel do not coincide in rotation direction
Sub error message: None
Possible causes: . Cassette compartment trouble or installation defect
. FG sensor trouble in supply reel motor or take-up reel
. Supply or take-up reel FG waveform shaper circuit (SV-206 board) trouble
. Supply reel motor trouble
. Supply reel motor drive circuit (SV-206 board) trouble
. Capstan motor trouble
. Capstan motor drive circuit (SV-206 board) trouble
. Capstan FG waveform shaper circuit (SV-206 board) trouble
. Servo adjustment defect on capstan, reel, and supply tension sensor
. Supply reel brake trouble
. Supply reel brake solenoid drive circuit (SV-206 board) trouble
. Harness disconnection
. Reel table height adjustment defect
. Tape path and drum troubles
. Tape abnormality (The winding state has a problem.)
Protecting operation: Stops the tape transport and enters the rest state.
c
Be sure to take out the cassette manually (refer to Section 1-11). Do not turn on
the power again without taking out the cassette. This may damage the tape.
2-6
tape supply value.
less than 15 g continuously for more than three seconds.
continuously for more than five seconds.
* The reel did not rotate because the cassette was lifted-up from the speci-
fied position.
BVW-55