Sony BVW-55 Maintenance Manual page 381

5-10. AT Head Azimuth Check and Adjustment
Adjustment procedure
8. Adjust the AT head azimuth
. Alignment tape : CR8-1A (3:00 to 4:55)
Turn the azimuth adjustment screw so that the
specification is satisfied.
Azimuth adjustment screw
AT head
In Case the Adjustment is Performed
9. Adjust the AT head head-to-tape
contact
(Refer to Section 5-11.)
10. Adjust the AT head position
(Refer to Section 5-8. )
11. Check the AT head height
6 cm
(Refer to Section 5-9.)
12. Check the AT head azimuth
(Refer to steps 6 and 7 in this section.)
6 cm A
13. Re-check the AT head
(Rerform the steps 9 and 10 again.)
14. Locking compound applying
(Refer to Section 5-1.)
Spec. A 0.52 cm
n
After adjustment are completed, be sure to set
S100-1 switch on the SV-206 board to OFF
position.
5-39
BVW-55 P2