Sony BVW-55 Maintenance Manual page 300

4-7. Reel Table Replacement
8. Reel table installation (2)
(1) Secure the reel table using the precision
screw.
(2) Move the reel table vertically and confirm
that the play exists.
9. Tension regulator band assembly
installation (when T reel table was
replaced)
Install the hook of the tension regulator band
assembly removed in step 1 to the shaft on the
band adjustment bracket, and then fasten it using
a new stop washer.
n
Be careful not to bend or damage the tension
regulator band assembly during installation.
10. S main brake assembly installation
(when S reel table was replaced)
Install the S main brake assembly.
(Refer to Section 3-12.)
11. Operation check
(1) Put the unit into the unthreading end state.
(2) Rotate the reel table while releasing the T
soft brake or S main brake with finger and
check that the reel table and idler rotate
smoothly.
Adjustment after replacement
12. FWD back tension adjustment
(when S reel table was replaced)
(Refer to Section 5-3-1.)
13. REV back tension adjustment
(when T reel table was replaced)
(Refer to Section 5-3-2.)
14. Tape running adjustment
(Refer to Section 5-4.)
4-28
BVW-55 P2