Sony BVW-55 Maintenance Manual page 298

4-7. Reel Table Replacement
Replacement
1. Tension regulator band assembly
removal (when T reel table is replaced)
(1) Turn the manual eject knob clockwise and
move the eject link to the position shown in
the figure.
(2) Remove a stop washer of the tension regula-
tor band assembly.
n
Do not apply excessive force to the tension
regulator arm assembly when the stop washer
is removed.
(3) Remove the hook of the tension regulator
band assembly from the mechanical deck.
n
Do not touch the felt surface of the tension
regulator band assembly with fingers. Do not
bend the tension regulator band assembly or
make oil adhere to the felt surface.
2. S main brake assembly removal
(when S reel table is replaced)
Remove the S main brake assembly.
(Refer to Section 3-12.)
3. Reel table removal
(1) Remove the precision screw on the top of the
reel table.
(2) Pull out the reel table while releasing the
tension regulator band assembly and T soft
brake arm or S main brake, which interfere
with the reel table, with finger.
n
Polywashers may adhere to the bottom of the
reel table. Return all polywashers to the reel
shaft in this case.
4-26
T reel table
Precision
M1.4 x 3.5
S reel table
Tension regulator
band assembly
Eject link
Stop washer
Hook
T soft brake arm
Tension regulator band assembly
Precision
M1.4 x 3.5
T reel table
T soft brake arm
BVW-55 P2