Siemens SINAMICS S120 Commissioning Manual page 38

Add infeed
1.12 SDO services
SDO Abort codes
Table 1- 8 SDO Abort codes
Abort code Description
0503 0000h Toggle bit not alternated
0504 0000h SDO protocol timed out
0504 0001h Client/server command specifier not valid or unknown
0504 0002h Invalid block size (block mode only)
0504 0003h Invalid sequence number (block mode only)
0504 0004h. CRC error (block mode only)
0504 0005h Out of memory
0601 0000h Unsupported access to an object
0601 0001h Attempt to read a write-only object
0601 0002h Attempt to write a read-only object
0602 0000h Object does not exist in the object dictionary
0604 0041h Object cannot be mapped to the PDO
0604 0042h The number and length of the objects to be mapped would exceed PDO length
0604 0043h General parameter incompatibility reason
0604 0047h General internal incompatibility in the device
0602 0000h Object does not exist in the object dictionary
0604 0041h Object cannot be mapped to the PDO
0604 0042h The number and length of the objects to be mapped would exceed PDO length
0604 0043h General parameter incompatibility reason
0604 0047h General internal incompatibility in the device
0606 0000h Access failed due to a hardware error
0607 0010h Data type does not match, length of service parameter does not match.
0607 0012h Data type does not match, length of service parameter too high.
0607 0013h Data type does not match, length of service parameter too low.
0609 0011h Subindex does not exist
0609 0030h Value range of parameter exceeded (only for write access)
0609 0031h Value of parameter written too high
0609 0032h Value of parameter written too low
0609 0036h Maximum value is less than minimum value
0800 0000h General error
0800 0020h Data cannot be transferred to or stored in the application
0800 0021h Data cannot be transferred to or stored in the application because of local control
0800 0022h Data cannot be transferred to or stored in the application because of the current device state.
0800 0023h Object dictionary dynamic generation failed or no object dictionary is present (e.g. object dictionary is
generated from file and generation fails because of a file error).
38
Commissioning Manual, (IH2), V2.6, 10/2008 Edition, 6SL3097-2AA00-0BP3
CANopen interface