Table of Contents
Advertisement
GRAPHIC PANEL
5.
Operating the Mixing Wheel (on the PART/MIXING Panel)
1)
When CHs are assigned
* Adjustment using the mixing wheel is only temporary editing and does not affect current recorded
data.
When CUE recording is performed on the STAGE screen, changes are recorded on the CUE.
* CH level adjustment is given priority over that performed on the STAGE screen.
* Geometrical or arithmetical reference values are initialized when the MANU/
before operating the mixing wheel. Therefore, the wheel makes it possible to adjust the level with
the amount calculated after the MANU/
Move the mixing wheel vertically to adjust the current STAGE level of the assigned CH.
Move the mixing wheel upward to raise the STAGE level.
Move the mixing wheel downward to lower the STAGE level.
The changes in the CH level can be seen on the STAGE screen.
2)
When EFFECTs are assigned
* Adjustment using the mixing wheel is only temporary editing and does not affect current recorded
data. Press the GO/FIX button on the top of the mixing wheel, and the edited data is recorded.
If the EFFECT for which time is being edited is on the EFFECT screen, the edited data is displayed
there.
Move the mixing wheel vertically to adjust the time of the assigned EFFECT (TIME).
Move the mixing wheel upward to make the TIME shorter.
Move the mixing wheel downward to make the TIME longer.
5.
Fixed Level CH Control
* When the same CH is assigned to more than one mixing wheel, that CH is handled as follows:
When the GO/FIX button on the top of the mixing wheel is pressed with a CH or CUE assigned to the
mixing wheel, the CH is controlled with the then-current STAGE level fixed. Although the mixing wheel
can be operated while the CH is controlled with the STAGE level fixed, assignments to MIXING
cannot be changed. The CH level during fixed control can be seen on the LIVE and STAGE screens.
Press the GO/FIX button again to cancel fixed CH control.
LED in the GO/FIX button is ON: The CH is under fixed level control.
LED in the GO/FIX button is OFF: The CH is not under fixed level control.
1)
Starting fixed level CH control
CH control with the STAGE level fixed starts when the GO/FIX button is pressed. If fixed control of the
same CH is set on another mixing wheel, the control set last is given priority.
2)
Cancellation of fixed level CH control
When the GO/FIX button is pressed again, fixed STAGE level CH control is canceled.
If fixed control of the same CH is set on another mixing wheel, that control is not canceled.
6.
Recording Edited EFFECT Time
When the GO/FIX button on the top of the mixing wheel is pressed with an EFFECT assigned to the
mixing wheel, the edited time of that EFFECT is recorded.
button was pressed.
40-9
button is pressed
Advertisement
Table of Contents
