Table of Contents
Advertisement
• If the breaker is tripped, eliminate the cause before resetting the breaker.
Failing to do so may start a fire, cause an electric shock or damage the device.
• If the fuse is blown, be sure to replace it with the same type with the same rating.
Using the incorrect fuses may start a fire or damage the device.
• Turn the power off before removing the panel.
Failing to do so may cause an electric shock.
• Be careful when removing the panel.
The panel may fall, causing injury.
2.
Precautions before use
• Before using this device, be sure to read the instruction manual and precautions.
Keep this manual at hand for quick reference.
• This device must be installed and prepared for use by a specialist such as a certified
stage/television lighting engineer.
Installation by an unskilled person may cause various problems.
• The device must be inspected daily.
If the results of an inspection show that the device does not meet any of the standards specified in
the instruction manual, deal with the issue according to the instruction manual.
• This device generates heat. Make sure that the location where the device is installed is
well-ventilated.
Failing to do so may start a fire, cause an electric shock, or damage the device.
• Confirm that this device is not exposed to direct sunlight, high temperatures, high levels of
humidity, dust, corrosive gases, vibration, impact, etc.
Otherwise these factors may start a fire, cause an electric shock, or damage the device.
• Make sure that the device is not installed in an unstable location.
Failing to do so may start a fire, cause an electric shock, damage the device or cause it to fall over.
• Make sure that the input power is properly connected.
Failing to do so may start a fire, cause an electric shock, or damage the device.
• Do not allow cables such as power cables and DMX cables to be pulled forcibly.
Failing to do so may cause electric shock or damage to the device.
• Do not subject the device to strong impact.
Doing so may start a fire, cause an electric shock or damage the device.
• Do not touch the device with wet hands.
Doing so may cause an electric shock.
• Make sure that the power cables and DMX cables are connected securely.
A loose connector may start a fire or damage the device.
Caution
Advertisement
Table of Contents
