Figure 6-4 Securing A Usb Cable To The Back Of The Equipment - Hitachi HF-W100E Instruction Manual

6. CHECKUP AND MAINTENANCE
・Securing a USB cable to the back of the equipment
(2) Securing a USB cable to the back of the equipment
1. See Figure 6-4 and secure the DisplayPort / USB removal prevention fittings to the
equipment with screws (M3 screw).
2. Attach the USB cable to the equipment and attach the Cable band.

Figure 6-4 Securing a USB Cable to the Back of the Equipment

(3) Removing the USB cable on the back of the equipment
Follow the procedure described in "(2) Securing a USB cable to the back of the equipment"
in reverse to remove the USB cable.
Also, since you can not reuse the cable band used once, prepare a new cable band for use
when the cable band is used again.
< NOTE >
When attaching the securing cable band, see the figure below and install it by the
installation method matching the number of USB cables to be attached to the
equipment.
USB cable 2 fixed
Fixing screw (M3 screw)
USB cable 1 fixed
Cable band
6-8
Cable band
DisplayPort / USB
removal prevention
fittings