Table of Contents
Advertisement
9.6 Failure Analysis Information Partition Mount Setting
9.6.1 "Confirmation of mount setting" message
In this equipment, a fault analysis information partition (H: drive) is placed and mounted as a
recording destination of fault analysis information such as Windows® event log.
The mount setting is checked at the time of Windows® startup, and when the mount setting is
not done correctly, a message box will be displayed to prompt the user.
If a message box is displayed, the mount setting of the fault analysis information partition will
be canceled and information for fault analysis, such as the Windows® event log, may not be
recorded, so see "9.6.2 Failure analysis information Partition check and mount setting
procedure " to check the fault analysis information partition and mount setting.
Fault analysis information and storage destination folder to be stored in the fault analysis
information partition are as follows.
Table 9-4 Failure Analysis Information and Storage Folder
No.
1
Windows® event log
2
Windows® minidump file
3
RAS software log information
4
User mode process dump file (* 1) H:\SystemLog\Windows\Appdump
(*1) The storage folder of the dump file of the user mode process is set in the following
registry.
Subkey: HKLM\SOFTWARE\Microsoft\Windows\Windows Error Reporting
Value name: DumpFolder
Value: C:\LogFolder\SystemLog\Windows\Appdump\%USERNAME%
Item
\LocalDumps
Folder structure
H:\SystemLog\Windows\winevt
H:\SystemLog\Windows\Minidump
H:\SystemLog\RAS_Software
9-21
9. TROUBLESHOOTING
Advertisement
Table of Contents
