Setting Up The Lan Interface - Hitachi HF-W100E Instruction Manual

2. OPERATION

2.7 Setting Up the LAN Interface

This equipment has three built-in 1000BASE-T/100BASE-TX/10BASE-T LAN ports. For
information about the location of the LAN port connector (1000BASE-T/100BASE-
TX/10BASE-T), see "1.4 Name and Function of Each Part".
< NOTE >
・ For information about the precautions for the network, see "PRECAUTIONS 2.
NETWORK".
● Automatic recognition of the network transfer speed or transfer mode
The LAN port has an auto-negotiation function to automatically recognize the network
transfer speed or transfer mode. For normal use, enable the auto-negotiation function.
(Especially when you use the WOL function. If the speed is fixed to 1000Mbps (auto-
negotiation), the WOL function cannot be used.)
If there is a compatibility issue with the connected hub, the auto-negotiation function may
not work properly and that may affect the communication with other terminals.
If the auto-negotiation function does not work properly, configure the LAN interface as
follows.
Specification of
the hub
10 Mbps / Half-
10 Mbps / Full-
100 Mbps / Half-
100 Mbps / Full-
1000 Mbps
(*) How the setting is displayed is different depending on the OS and the
LAN port in use.
10 Mbps
duplex
10 Mbps
duplex
100 Mbps
duplex
100 Mbps
duplex
1000 Mbps (1.0 Gbps)
Specification of the LAN setting (*)
Speed
Auto Negotiation or
2-8
Duplex
Half Duplex
Full Duplex
Half Duplex
Full Duplex
Full Duplex