Setting Up The Lan Interface - Hitachi HF-W2000 58 Instruction Manual

2. OPERATION

2.8 Setting Up the LAN Interface

This equipment has three built-in 1000BASE-T/100BASE-TX/10BASE-T LAN ports. For information about the
location of the LAN port connectors (1000BASE-T/100BASE-TX/10BASE-T), see 1.5 Name and Function of Each
Part.
NOTE
• For information about the precautions for the network, see 2. Networks in PRECAUTIONS.
● Automatic recognition of the network transfer speed and transfer mode
The LAN port has an auto-negotiation feature that automatically recognizes the network transfer speed and
transfer mode. During normal use, enable the auto-negotiation feature. (Use the auto-negotiation feature when
using the WOL feature. Note that if the speed is fixed to 1000 Mbps, the WOL feature cannot be used.)
If there is a compatibility issue with a connected hub, the auto-negotiation feature might not work properly, which
might affect communications with other terminals.
If the auto-negotiation feature does not work properly, configure the LAN interface as follows:
Specification of the hub
10 Mbps, half-duplex
10 Mbps, full-duplex
100 Mbps, half-duplex
100 Mbps, full-duplex
1000 Mbps
#: Settings are displayed differently depending on the OS and LAN port (including the optional
LAN adapter) being used.
LAN setting specifications
Speed
10 Mbps
10 Mbps
100 Mbps
100 Mbps
1000 Mbps (1.0 Gbps)
2-10
#
Duplex
Half duplex
Full duplex
Half duplex
Full duplex
Full duplex