Starting The Equipment - Hitachi HF-W2000 58 Instruction Manual

2. OPERATION

2.2 Starting the Equipment

To start the equipment:
1. Plug the power cord into an outlet.
When the power cord is plugged into an outlet, the standby lamp (STBY) will turn on.
2. Turn on the power to the display.
3. Press the power switch. (See 1.5 Name and Function of Each Part.)
When the power is turned on, the standby lamp (STBY) turns off and the status lamp (STATUS) lights. The
status lamp turns red when the power is turned on and green when the OS starts and the equipment is operating.
4. After the OS starts, set up the equipment as described in 3.1 Setup Procedure When Turning On the Power for
the First Time. (This procedure is required only once, the first time you start the equipment after purchasing
the equipment.)
NOTE
• When RAS software is not installed or during the recovery process, the status lamp (STATUS) does not turn
green and remains red.
After these steps are complete, the equipment automatically performs the startup process until the sign-in screen
appears.
For information about controlling the power by using a LAN, see 2.7 Controlling the Power By Using a LAN.
2-2