Table of Contents
Advertisement
10. SOFTWARE RAID1
(2) Replacing the HDD while the power to the equipment is turned on
NOTE
You need to have administrator privileges to execute step 3. Log on to the equipment as an administrator account
and click OFFLINE. If User Account Control (UAC) is enabled, in a confirmation message, click Yes. The User
Account Control window is displayed. Then click Continue.
Note that if User Account Control (UAC) is disabled and a user without administrator privileges clicks OFFLINE,
the HDD is not disconnected.
1. Back up your data.
2. Close all running applications.
3. Double-click the hardware status icon on the notification area of the taskbar.
The Hardware status window appears. In the Hardware status window, under Drive bay1, click OFFLINE to
set the HDD to offline mode.
Verify that the DRIVE1 status lamp is on.
It might take 20-30 seconds or more for the DRIVE1 status lamp to turn on.
4. Execute steps 4 through 7 in 10.4.2(1)(a) Replacing an HDD with the equipment turned on to rebuild the array.
Hardware status window
10-24
Hardware status icon
Advertisement
Table of Contents
