Hitachi HF-W2000 58 Instruction Manual page 131

5. SPECIFICATIONS
Top
menu
Advanced Power
Configuration
Setting item
After AC Power On
Fan Failure Detection Enabled
Fan Speed Control
Cx State Enable
Default
value
Auto Specifies settings that govern the behavior when
power is restored after power is lost.
Stay Off: When the power is turned on, the system
goes into the soft power off mode.
Power On: When the power is turned on, the OS
starts automatically.
Auto: If the OS was running the last time the power
was turned off, the OS starts as in the case of Power
On. If the OS was not running the last time the
power was turned off, the system goes into the soft
power off mode as in the case of Stay Off.
If the backup battery runs out of power or if the
battery is not connected, the settings operate the
same way as Stay Off when the power is turned off.
If the backup battery runs out of power or the
battery is replaced, the applicable settings value
reverts to the default (Auto).
Specifies whether to detect fan failures when the
power is turned on.
Option: Enabled, Disabled
Specifies the rotational speed of the fan.
Auto: The fan speed changes automatically
Auto
according to the CPU temperature.
Full: Fan speed is always at maximum.
Changes the behavior of the processor power state
Disabled (Cx).
Options: Disabled, Enabled
5-14
(3/5)
Notes